In the selection of lost circulation material (LCM) it is very important to determine its shut-off capacity to the formation. Working Pressure is 0-7MP a
The HTHP Filter Press is designed to evaluate the filtration characteristics of drilling fluids, cement slurries, fracturing fluids, and completion fluids under elevated temperatures and pressures. Maximum Temperature : 500℉ (260℃) 500 ml Single Capped Sample Cell for Filter Paper
The Filter Presse is the most effective means of determining the filtration properties of drilling muds and cement slurries. 500ml Sample Cell, Working pressure is 100 psig and the filtering area is 7.1-in2. CO2(N2) Tanks with Assembly
The Mud Testing Kit is designed to provide all necessary drilling fluid testing equipment required for field testing of drilling fluids according to API Recommended Practice 13B-1. All kits may be custom designed to meet customers' individual specifications. Special requests and suggestions are always welcome.
Viscosity factor meter is used to measure and appraise the lubricity of drilling fluid and quality compatibleness of drilling fluid lubricant. The meter has the characters of reasonable structure, reliable work, high accuracy and good repetitiveness Turnover speed:5.5-6.5minutes/round Angle reading:Accuracy by number:0.5
The High-Pressure, High-Temperature (HPHT) Consistometer measures cement slurry viscosity or consistency under elevated pressure and temperature conditions. Maximum operating temperature of 600 ℉ (275℃) UNIT working pressure: 40,000psi (2750 kPa)
Standard crush or non-destructive compressive-strength tests are performed on cement slurry samples under simulated downhole pressure and temperature conditions to determine the initial set time and the wait-on-cement (woc) time. Temperature: up to 700℉ (370℃) Pressure: up to 5,950psi (41mPa) 8 cube mold set, (Single Cell)
The mixers are recommended for use in general purpose mixing of drilling fluids in preparation for laboratory tests of mud materials. 3 spindles,Volume: 1500ml*3 Speeds: 0-18,000 RPM, No of Speeds: 3(Low, Medium, High).
Roller Ovens provide an excellent method of aging fluid samples for further analysis. Temperature Range:600℉ (315℃),Capacity 8 unit cells. Digital temperature controller and Protection against over-temperature. The primary tool for this aging is a roller oven.The time period needed to more fully develop properties in a drilling fluid varies from as little as several hours (usually 16 hours) to as long as several days. The aging can be done at either ambient or elevated temperatures.
The Model RCMB Series Mud Balance provides a simple, practical method for accurate determination of fluid density. Measuring Range (4 Scales): 6-25 lb /gal ; 310-1300 lb /sq in/100ft of depth ; 45-190 lb /cu ft ; 0.72-3.0 gms /cm3 Specific Gravity